Axe Sharpening Jig at

Axe Sharpening Jig at

Used for Carving and Carpenter's Axes The Head of the Axe Supports Freely on the Rubber Lined Stop The Wedge Shaped Stop holds the Axe Firmly in

Axe Sharpening Jig for Tormek Sharpeners Tormek SVA-170 Axe Jig. Makes Sharpening Quick and Intuitive For Almost Any Shaped Carving or Carpenters Axe

The jig (1) comprises an upper base with a lower clamp and two locking knobs for fixing the tool. The jig slides on the Universal Support on nylon bushings across the grindstone. The edge angle is set with the Micro Adjust (4) on the Universal Support (5). There are two safety stops to prevent the tool from slipping off the stone when grinding. One inner stop (2) to be positioned according to the width of the tool and one outer stop (3) mounted on the end of the Universal Support.

Tormek Axe Jig

DIY Sharpening System From a Broken Breadmaker : 13 Steps (with

Angle Adjustable Sharpener Woodworking Tool Sharpening Jig

Tormek T-4 Bushcraft Water Cooled Sharpening System, Includes

Will work with both 6” and 8” diameter grinders and belt sanders with 1” wide wheel or belt Mounts directly to bench and can be quickly removed to allow free hand grinding Tool rest comes with a grinding jig that will accept blades/chisels up to 2.5 inches wide Can easily move forward/back, up/down and rotate Constructed from anodized aluminum and will never rust. Most bench grinders come equipped with a tool rest that is almost useless.

Bench Grinder Replacement Sharpening Tool Rest Jig for 6 and 8 Grinders and BG

Homemade lathe tool sharpening jig

Sharpening jig - Tools and Tool Making - Bladesmith's Forum Board

Lathe tool sharpening jig cut in Oak using thin router bit